TEACHING THE RECEIVER WHICH CODES TO ANSWER (LEARN MODE)

1. Push & quickly release the white button on side of receiver.

2. Within the next few seconds, push the transmitter button you want to use and hold it until the red LED on the receiver comes on again (about 4 seconds). Release the transmitter button. Immediately push button on second, third or fourth transmitter until LED comes on (if multiple transmitters are desired).

3. Wait 5 seconds until the red LED flashes 3 more times before using the system.

SETTING OUTPUT MODES FOR CMH RECEIVER

1. Push and hold the white button on the side of the receiver until you see the red LED flash the number of times that corresponds to the desired relay output.

2. Release the button at the desired mode.

Momentary (1 flash): 130-millisecond relay closure.

Latching (2 flashes): Closes relay until you push again (flip-flop).

Sustaining (3 flashes): Closes the relay for as long as you hold down transmitter button.

3. You can change the relay output mode without affecting the “learned” transmitter codes.